Supported hardware

The SDK should work with any equipment that a Hayward OmniLogic controller supports.

Verified

The equipment layer is verified on hardware with this equipment:

• Hayward OmniPL, MSP firmware R0502000
• Pool and spa that share one filter pump, heater, and chlorinator
• Hayward TriStar VS 950 Omni filter pump
• Hayward Smart Heater (gas)
• Salt chlorinator with a TCELLS340 cell
• Universal ColorLogic (UCL) lights, with or without OmniDirect (a light mode that adds colors, a show speed, and a brightness)
• High voltage relays
• Air temperature, water temperature, and flow sensors

Unverified

• Salt chlorinator cells
  • T-Cell-3
  • T-Cell-5
  • T-Cell-9
  • T-Cell-15
  • T-Cell-LS
  • TCELLS315
  • TCELLS325
• AQR940/AQR925 Aqua Rite chlorine generator, with an HLAQRPCB communication board
• Feeders and dispensers
  • HL-CHEM4-CHLOR liquid chlorine feeder
  • CL200 chlorine tablet feeder
  • HL-CHEM4-ACID liquid acid feeder
  • AQL-CHEM2 CO2 dispenser
• HL-CHEM Sense and Dispense ORP and pH sensing kit
• Pumps
  • TriStar VS 900 Omni
  • Super Pump VS 700 Omni
  • MaxFlo VS 500 Omni
  • EcoStar
  • Single-speed and dual-speed filter pumps
  • Cleaner, water feature, and accessory pumps
• Heat pump, solar, electric, and geothermal heaters
• Chillers
• Lights
  • ColorLogic 2.5 (CL2.5)
  • ColorLogic 4.0 (CL4.0)
  • Universal ColorLogic in Pentair SAM mode
  • WaterBowl
  • Pentair Color LED (P-COLOR)
  • Jandy Color LED (Z-Color)
  • Incandescent
  • LTSUY11300 Smart Power Transformer
• Valve actuators
  • V&A-xx valve and actuator
  • Pentair/Compool and Jandy valve actuators
• Relays and expansion
  • Low voltage relays
  • HLRELAYBANK additional relay pack
  • HLRELAY single high voltage relay kit
  • HLH485RELAY Smart Relay
  • HLEXPAND Expansion Panel
  • HLIOEXPAND Input/Output Expander Board
• Sensors and inputs
  • GLX-FLO flow switch
  • 2PC temperature sensor
  • Solar sensor
  • External input interlocks

Unverified lights, relays, pumps, heaters, chlorinators, and Sense and Dispense equipment should work through the equipment layer. If not, use command() instead.

import { OmniLogic, timerParams } from "@rygine/omnilogic-local-sdk";

const omni = new OmniLogic({ host: "192.168.1.100" });

// fetch config and telemetry
await omni.refresh();

// turn on a piece of equipment by its id
await omni.command("SetUIEquipmentCmd", {
  poolId: 1,
  equipmentId: 12,
  isOn: 1,
  ...timerParams(),
});